DIY : Mermaid Tail





Every girls dream is to be a mermaid.
So lets leave reality and be mermaids for just a little bit.
I am making this costume for my sweet Ella.
This is, I think, the third time she is being a mermaid for Halloween.
But I cant blame her, I was a cheerleader almost every year when I was little.



So here it is
A super easy DIY mermaid tail
Level Beginner

I can say this is a beginner because I am a tutu maker and not much of a sewer at ALL.
I didn't even use a pattern.
Just took the monofin and went from there.


Start by
Gathering Your Supplies

Monofin from Target
Swimsuit Fabric from Joannes
Thread
Scissors
Measuring Tape
Sewing Machine
Cardboard
pins


Measure your child from belly button to the end of the fin.
I laid Ella down then measured
and stood her up and measured again
Next Trace the fin onto the cardboard and set aside


I took two different fabrics, one for the legs and one for the fin.
Cut two pieces of fabric the length of her legs
Turn the fabric where both shiny pieces are facing each other
Pin down the side
Sew down that one side only



Now place the fabric on your child
Pin down the other side
Pull tight when pinning
It is ok if it is a little small
the material is stretchy
Sew down the other side
Place back on your child to see if it fits
Then trim the excess material off


Trim excess material off
Have your child sit down
See if the tail is too long
If it is too long, then pin at the ankles
and trim about an inch below the pin



Now cut your fin out of the cardboard
Trace onto the wrong side of the material
Pin the fin together on the inside of the marks you made
Cut out fin 1/4 inch outside of the traced line
You have two pieces of material pinned together with wrong side out


Sew down each side of the fin
DO NOT sew the bottom of the fin
You will only sew about 2 inches of the bottom to create a pocket for the fin


Slide fin into the material to make sure it fits

Turn fin material inside out
Keep mermaid tail with shiny side out
Slide mermaid tail into fin
Pin the ends together
Sew into place



To put tail on
Have your child place her feet through the tail first
Flip up the fin material
Put the monofin on
Now slide the material over the fin and put the tips into the pockets


For the top, I took the scraps and just sewed a tube top
Then added some ruffles from the leftover rainbow material


All done! Super Easy



Comments

  1. Kamagra (Sildenafil) is an ingredient which is present in Viagra. It is an FDA approved the oral medication for the treatment of erectile dysfunction (ED). Viagra is the brand name of the medicine which is being invented by Pfizer. Kamagra assists in the relaxation of blood vessels and improves the flow of blood towards the pen*s for achieving hard and also long lasting erection. We also have in stock (kamagra 100mg,Buy kamagra 100mg,Cheap Kamagra 100mg,Kamagra 100mg Tablets,Kamagra,kamagra tablets how to use,kamagra sildenafil 100mg,Kamagra Gold,kamagra gold 100,kamagra 100 gold,Kamagra Effervescent,Kamagra oral jelly review,buy kamagra oral jelly,kamagra jelly,buy kamagra jelly online,kamagra 100mg oral jelly,kamagra 100mg oral jelly how to use,kamagra 100 mg oral jelly,kamagra oral jelly 100mg,kamagra chewable,kamagra 100 chewable tablet,kamagra soft tablets,kamagra soft tabs,best place to buy Kamagra online,Super Kamagra 100mg) which is used to treat the same indications.

    ReplyDelete
  2. The Vidalista (Tadalafil, also known by the Brand Name Cialis), which is one of the most prescribed drugs, that are meant for the treatment of erectile dysfunction. In contrast to other oral medications which have been prescribed for ED, the effect of Tadalafil may last for up to 36 hours, and this is a reason why it is also called as the weekend pill. We also have in stock (Vidalista,Vidalista 40,Vidalista 40 reviews,Tadalafil 80 mg,Tadalafil chewable,Tadalafil sublingual) which is used to treat the same indications.

    ReplyDelete

Post a Comment

Popular Posts